Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 718)

Paramacros
Chapter 28
28-18
Table 28.D
System Parameters (continued)
Parameter # System Parameter Page
5731 to 5743 Home Marker Distance 28-33
5751 to 5763 Home Marker Tolerance 28-34
1 These parameters may only have their value received (read-only)
2
These parameters may only have their value changed (write-only)
#2001 to 2999
Tool Offset Tables
These parameters may be changed or simply read through programming.
The values for these parameters are received or entered into the tool offset
tables for geometry and wear (discussed in chapter 3). Table 28.E gives
the parameter numbers associated with each table value.
Table 28.E
Tool Offset Table Parameters
Offset
Number
Parameter # for
Geometry Table
Parameter # for Wear
Table
Tool Length 1 to 99 #2001 to 2099 #2201 to 2299
Tool Radius 1 to 99 #2401 to 2499 #2601 to 2699