Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 98)

Offset Tables and Setup
Chapter 3
3-24
2. Press the {PROGRAM PARAM} softkey.
(softkey level 2)
PRGRAM
PARAM
AMP DEVICE
SETUP
MONI-
TOR
TIME
PARTS
PTOM
SI/OEM
3. Press the {F1 - F9} softkey to display the single digit feedrate table as
shown in Figure 3.8.
(softkey level 3)
ZONE
LIMITS
F1-F9 MILCYC
PARAM
PROBE
PARAM
Figure 3.8
Single Digit Feedrate Table
ENTER VALUE:
1-DIGIT F-WORD FEEDRATE [MMPM]
F1 .01000
F2 .02000
F3 .03000
F4 .04000
F5 .05000
F6 .06000
F7 .07000
F8 .08000
F9 .09000
REPLCE
VALUE
ADD TO
VALUE
UPDATE
& EXIT
QUIT
Important: Feedrates are displayed in inch or metric depending on which
is the active mode on the system at the current time. IPM (inches per
minute) or MMPM (millimeters per minute) is displayed at the top of the
screen, indicating the currently active mode.