Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 196)

Running a Program
Chapter 7
Running a Program
Chapter 7
7-14
Important: The search with recall feature will not:
send PAL nonmodal M--codes including user--defined groups 0 -- 3,
group 4, group 5, and group 6 M--codes.
on dual process systems, halt execution for synchronization codes.
read from or write paramacro variables to PAL
on dual process systems, shared paramacro variables between processes
may not be evaluated as desired depending on the status of the other
process.
Important: This feature will not search into any cycle that calls a set of
profile blocks (typically specified with the P-- and Q--word in the cycle).
Refer to the description of your cycle for details on profile blocks.
send to PAL gear change requests based on spindle speed
To perform a program search with recall, follow these steps:
1. Press the {PRGRAM MANAGE} softkey.
(softkey level 1)
PRGRAM
MANAGE
OFFSET MACRO
PARAM
QUICK
CHECK
SYSTEM
SUPORT
FRONT
PANEL
ERROR
MESAGE
PASS-
WORD
SWITCH
LANG
2. Press the {ACTIVE PRGRAM} softkey.
REFORM
MEMORY
ACTIVE
PRGRAM
EDIT
PRGRAM
RESTRT
PRGRAM
DISPLY
PRGRAM
COPY
PRGRAM
VERFY
PRGRAM
PRGRAM
COMENT
DELETE
PRGRAM
RENAME
PRGRAM
INPUT
DEVICE
(softkey level 2)
Make sure that the program to search is the currently active program.
If it is not, select it for automatic execution as discussed in section
7.3.