Rockwell Automation 8520-MUM 9/Series CNC Mill Operation and Programming Manual Documentation Set - Manual (Page 932)

Allen-Bradley 7300 Series CNC
Tape Compatibility
Appendix D
D-10
Table D.C (continued)
Mill G-codes Available in 7300 Mode
G-code: Description:
G49 Tool length cancel
G52 Offset coordinate zero point
G53 Motion in machine coordinate system
G54 Preset work coordinate system 1
G55 Preset work coordinate system 2
G56 Preset work coordinate system 3
G57 Preset work coordinate system 4
G58 Preset work coordinate system 5
G59 Preset work coordinate system 6
G61 Exact stop mode
G62 Automatic corner override
G63 Tapping mode
G64 Cutting mode
G65 Paramacro call
G66 Paramacro modal call
G67 Paramacro modal cancel
G68 Part rotation
G69 Part rotation cancel
G92 Coordinate offset using tool positions
G95 Feed per revolution mode
The control does not support these 7300 Series CNC features:
7300 Scaling (using “SCF” with G-codes)
7300 Part Rotation
Additional Plane Selection (beyond G17, G18 and G19)
7300 Tool Axis Switching
7300 Cutter Compensation Entry and Exit Motion
All cutter compensation moves, except for the entry and exit moves, use the
same paths for 7300 and control. However, the entry and exit moves of cutter
compensation uses the control’s tool paths. Refer to chapter 21 for details.
END OF APPENDIX
7300 Series Features Not
Supported