SkyTrak 6042 Service Manual - Manual (Page 89)

3.43 Model 6042 Legacy Origin 7/02
Boom
Figure 3-92 Quick Attach
36. If the inner boom has been replaced with a new
boom, the auxiliary hydraulic fittings need to be
reassembled:
a. Assemble the two bulkhead fittings (Fig. 3-93, 1)
from the original boom to the bulkhead plate
inside the gooseneck. Insert the bulkhead fittings
from the top and secure in place with the
bulkhead fitting nut (2) on the bottom side.
Tighten securely.
b. Assemble the two swivel straight connectors
(Fig. 3-93, 3) to the two bulkhead fittings.
c. Assemble the male nipple (Fig. 3-93, 4) and dust
cap (5) to the right side swivel connector fitting.
Tighten the swivel connector and male nipple
securely. Assemble the dust cap onto the male
nipple. Assemble the female coupler (6) and dust
plug (7) to the left side swivel connector fitting.
Tighten the swivel connector and female coupler
securely. Insert the dust plug into the female
coupler.
Figure 3-93 Auxiliary Hydraulic Coupler and Nipple
d. Assemble the left auxiliary hydraulic hose
(Fig. 3-94, 1) labeled “Female Coupler” from
inside the gooseneck to the female coupler (2)
bulkhead fitting. Tighten securely.
e. Assemble the right auxiliary hydraulic hose
(Fig. 3-94, 3) labeled “Male Nipple” from inside
the gooseneck to the male nipple (4) bulkhead
fitting. Tighten securely.
Figure 3-94 Auxiliary Hydraulic Hoses
MH1720
2
3
4
6
5
1
2 3
~
MH1730
6
1
2
3
4
5
7
2
3
MH0841
1
2
3
4