SkyTrak 6042 Service Manual - Manual (Page 472)

Electrical System
9.102 Model 6042 Legacy Origin 7/02
9.14 CAB HEATER AND FAN (OPTION)
9.14.1 Cab Heater Controls
Note: If the suspect component is found to be within the
heater box, the heater box must be removed as a
complete unit and replaced. For additional information on
the removal and installation of the heater box, refer to
Section 4.4.4, a. “Heater Assembly Removal.”
Figure 9-76 Cab Heater and Fan Controls Locations
The cab heater controls are located directly below the
switch banks on the right side dash panel. The control
panel (Fig. 9 -76, 1) consists of a variable speed fan
control knob (2) and a temperature control knob (3).
a. Cab Heater Controls Removal
Note: After determining which control knob is not
functioning, remove only the suspect control knob. In
order to remove either knob, the cab heater and fan
control panel must be removed from the dash panel.
1. Disconnect the negative (–) battery cable at the
negative battery terminal (Fig. 9 -77, 1).
Figure 9-77 Battery Cable Connections
MA8700
3 2
4
5
8
7
6 1
9
MA8410
1