SkyTrak 6042 Service Manual - Manual (Page 513)

10.7 Model 6042 Legacy Origin 7/02
Stabil-TRAK™ System
10.3.3 Relay Testing
If after checking the electrical system, a relay is suspect,
test the relay as follows:
1. Park the vehicle on a firm, level surface. Level the
vehicle, ground the attachment, place the travel select
lever in the (N) NEUTRAL position, place the neutral
lock lever in the (N) NEUTRAL LOCK position, engage
the parking brake switch and shut the engine OFF.
2. Place an Accident Prevention Tag on both the
ignition key switch and steering wheel, stating that
the vehicle should not be operated. (Refer to Section
1.5, “Accident Prevention Tag Usage.”)
3. Disconnect the battery negative (-) cable
(Fig. 10 -10, 1) at the battery negative (-) terminal.
Figure 10-10 Disconnect the Battery Negative (-) Cable
4. The fuse panel is mounted behind the right side
console panel (Fig. 10 -11, 1). To gain access,
remove the four button-head screws (2) and remove
the console panel (1).
Figure 10-11 Remove the Console Panel
5. Remove the relay from the fuse panel.
6. Apply 12 volts to terminal 86 (Fig. 10-12 and
Fig. 10-13, 1) and attach the ground (-) probe to
terminal 85 (2). An audible click should be heard,
indicating the relay is functioning properly.
Figure 10-12 Relay Terminals
Figure 10-13 Relay Internal Components
OH2420
1
OH2430
2
1
~
86
85
30
87
87A
MN1820
1
2
87A
87
86 85
30
MT3140
2
1