SkyTrak 6042 Service Manual - Manual (Page 222)

Engine: Cummins 4BT3.9
7.28 Model 6042 Legacy Origin 7/02
24. Remove the right side exhaust pipe mount bracket
(Fig. 7-37, 1) and hex-head capscrews (23) and
lockwashers (24) from the rear engine mount bracket
(2).
Note: Always discard used elastic locknuts and install
new elastic locknuts.
25. Remove the elastic locknut (Fig. 7-37, 3), rebound
washer (4), engine isolator (5) and hex-head
capscrew (6) from the front right (7) and left (8)
engine mounting brackets.
26. Remove the hydraulic line clamps on both the right
and left sides of the engine.
27. Remove the four elastic locknuts (Fig. 7-37, 9), flat
washers (10) and two engine hold-down plates (11)
securing the lower rear engine mount bracket (12) to
the vehicle frame.
28. Position a fork truck behind the vehicle and drive
forward placing the forks underneath the upper rear
engine mount (Fig. 7 -37, 2) and front right (7) and
left (8) engine mount brackets. Slightly lift the
engine, and back the engine out of the vehicle. Have
an assistant ensure that the engine clears all frame
components during removal.
29. Place engine on a flat, level surface.
30. If replacing the engine, attach a lifting chain to the
front (Fig. 7-37, 13) and rear (14) engine lift bracket
and lift engine clear of the ground.
31. Remove the front right (Fig. 7-37, 7), and left (8)
engine mounting brackets and muffler bracket (15).
32. Remove the upper rear (Fig. 7-37, 2) and lower rear
(12) engine mount brackets from the engine. Inspect
isolators (16 and 17) and replace if worn.
33. Remove all radiator and oil cooler components from
the engine. (Refer to Section 7.6.3, “Radiator/Oil
Cooler and Coolant Heater Replacement.”)