SkyTrak 6042 Service Manual User Manual
Page 476
Electrical System
9.106
Model 6042 Legacy
Origin 7/02
d. Ignition Switch Installation
1. Connect the ignition key switch to the cab harness
connectors.
2. Reach up and under the dash to work the ignition
switch into the ignition switch-mounting hole on the
lower right side of the dash (Fig. 9-81, 1).
Figure 9-81 Ignition Key Switch Location
3. The ignition switch (Fig. 9-82, 1) has a drain hole
located on the shaft, between the backing nut and
the face of the ignition switch cylinder (2), behind the
dash panel (3). Align the ignition switch so that when
it is in the OFF (4) position, the key slot (5) is positioned
vertically (straight up and down) and the indicator
mark (6) for the drain hole, is pointing down. Install
the hex nut securing the ignition switch to the dash.
DO NOT overtighten.
4. Install the lower access panel (Fig. 9 -81, 2).
Figure 9-82 Ignition Key Switch
5. Connect the negative (–) battery cable at the
negative battery terminal (Fig. 9 -83, 1).
Figure 9-83 Battery Cable Connections
OH1760
1
2
MA10,0000
2
3
6
5
1
4
MA8410
1