Electrical system – SkyTrak 6042 Service Manual User Manual
Page 405
9.35
Model 6042 Legacy
Origin 7/02
Electrical System
If OK
Not
OK
Check for battery voltage at
wire 9 (GRY/BLK) at
steer select valve solenoid.
Check wire 2C (BLK) ground
connections.
With steer select switch
in 4-wheel steer mode,
only 2-wheel steering
is active.
additional information.
Check steer select valve
solenoid resistance. Should
have 5 to 7 ohms resistance.
If OK
Check 10-amp steer
select fuse.
Replace steer select
valve solenoid.
If OK
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. Fuses.
2. All connections relating
to circuit are clean and
tight.