SkyTrak 6042 Service Manual - Manual (Page 142)

Cab and Covers
4.22 Model 6042 Legacy Origin 7/02
3. Pull the hoses (Fig. 4-37, 1 and 2) through the
grommets, and connect to the heater. Secure with
two hose clamps.
4. Install the heater access panel (Fig. 4-37, 3) and
secure with four button-head screws (4) and four
acorn nuts (5).
Figure 4-37 Install the Heater Access Panel
5. Fill the cooling system completely with a 50/50 mixture
of ethylene glycol and water, allowing time for the
coolant to fill the engine block. The cooling system
capacity is listed in “Specifications,” Section 2.
6. Connect the battery negative (-) cable.
IMPORTANT: When the engine is initially started, run it
briefly at low idle and check the vehicle for any visual
sign of fluid leakage. STOP the engine immediately if
any leakage is noted, and make any necessary repairs
before continuing.
7. Wait for the engine to cool and check the coolant
level. Add coolant to the overflow bottle as required
to bring the coolant to the proper level.
MA8720
5
3
5
1
4
2
WARNING:
The cooling system is under
pressure, and escaping coolant can cause
severe burns and eye injury. To prevent
personal injury, NEVER remove the radiator
cap while the cooling system is hot. Wear
safety glasses. Turn the radiator cap to the first
stop and allow pressure to escape before
removing the cap completely.