SkyTrak 6042 Service Manual - Manual (Page 115)

3.69 Model 6042 Legacy Origin 7/02
Boom
3.6.3 Quick Attach Removal
1. Remove the elastic locknut (Fig. 3-153, 1) and
capscrew (2) holding the attachment tilt cylinder rod
end pin (3) to the quick attach assembly (4). Save
the capscrew and discard the elastic locknut.
2. Support the rod end of the attachment tilt cylinder.
Use a brass punch and rawhide hammer to remove
the rod end pin (Fig. 3-153, 3) from the quick attach
assembly.
3. Inspect the pin (Fig. 3-153, 3) for nicks or surface
corrosion. Use fine emery cloth to fix minor nicks or
corrosion. If damaged or if it cannot be repaired the
pin must be replaced.
Figure 3- 153 Attachment Tilt Cylinder
Rod End Pin Removal
4. Remove the elastic locknut (Fig. 3-154, 1) and
capscrew (2) holding the quick attach pivot pin (3) to
the quick attach assembly (4). Save the capscrew
and discard the elastic locknut. Place a support
under the quick attach assembly to prevent it from
dropping when the pivot pin is removed.
5. Use a brass punch and rawhide hammer to remove
the quick attach pivot pin (Fig. 3-154, 3) from the
quick attach assembly and the bushings in the
gooseneck. Record the location and quantity of the
shim washers (5) as the pin is being removed. Save
the washers (6) from each side of the quick attach.
6. Inspect the pin (Fig. 3-154, 3) for nicks or surface
corrosion. Use fine emery cloth to repair minor nicks
or corrosion. If damaged or if it cannot be repaired,
the pin must be replaced.
Figure 3-154 Quick Attach Pivot Pin Removal
MH0940
1
3 2
4
~
MH0950
5
4
3 2
1
5
6
6
~