SkyTrak 6042 Service Manual - Manual (Page 413)

9.43 Model 6042 Legacy Origin 7/02
Electrical System
If OK
Not
OK
Check for battery voltage at
wire 6D (RED/WHT) and
wire 6E (RED/WHT) at
cab/washer harness
connections. Check
wire 1C (BLK) ground
connection.
Washer does not spray
water on front and top of
windshield.
Replace wiper/washer
harness.
If OK
Check reservoir for washer
fluid. Check hose
connections. Check 10-amp
washer fuse.
Replace washer
reservoir assembly.
If OK
Clean and retighten ring
terminal.
Not
OK
If OK
Check ground connection,
wire 1 (BLK) at washer
pump motor.
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. Fuses.
2. All connections relating
to circuit are clean and
tight.
Replace wiper
switch.
Not
OK
Check for battery voltage on
wiper switch connector at
wires 10 (GRN).
Replace wiper/
washer harness.
Not OK If OK
With washer switch ON,
check for battery voltage at
wire 10 (GRN) at washer
pump motor connection.