SkyTrak 6042 Service Manual - Manual (Page 421)

9.51 Model 6042 Legacy Origin 7/02
Electrical System
With the ignition ON and
the lighting control pushed
up for left turn signal or
down for right turn signal,
turn signal indicator and
turn signals remain OFF.
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. Fuses.
2. All connections relating
to circuit are clean and
tight.
3. Before troubleshooting
the turn signal circuit,
verify that the hazard
light circuit is operating.
If not, follow the steps
listed at, Section 9.7.23,
“Roadlights Hazard
Lights Circuit and
Troubleshooting
(Option),” before
troubleshooting the turn
signal circuit.
4. Before troubleshooting
the turn signal circuit,
verify that the worklight
circuit is operating. If
not, follow the steps
listed at, Section 9.7.27,
“Roadlights Worklights
Circuit and
Troubleshooting
(Option),” before
troubleshooting the turn
signal circuit.
5. If one of the turn signals
work, the circuit is fine,
the bad bulb needs to be
replaced.
Not
OK
With hazard switch OFF,
check for battery voltage at
pin 8, wire 1B (RED) on
hazard switch.
Replace roadlight harness.
Replace roadlight harness.
Not
OK
If OK
Check for battery voltage at
pin 1, wire 1B (RED) on
hazard switch.
Not
OK
If OK
Check for battery voltage at
pin 2, wire 33 (VIO) on hazard
switch.
Replace hazard switch.
Not
OK
If OK
Disconnect six position plug
at lighting control and check
for voltage at roadlight
harness pin F, wire 28A (VIO).
Replace roadlight harness.
Not
OK
If OK
Check for battery voltage at
pin L, wire 28 (VIO) on
flasher.
Replace flasher.
Not
OK
If OK
Connect six position plug at
lighting control and try turn
signals.
Replace lighting control.
Not
OK
If OK
Check for battery voltage at
pin X, wire 33 (VIO) on
flasher.
Replace roadlight harness.