SkyTrak 6042 Service Manual - Manual (Page 116)

Boom
3.70 Model 6042 Legacy Origin 7/02
3.6.4 Quick Attach Installation
1. Assemble the quick attach to the gooseneck. Line up
the quick attach (Fig. 3-155, 1) between the mounts
on the gooseneck. Assemble a washer (2), saved,
on each side of the quick attach. Reassemble the
shims (3), saved, between the quick attach and the
gooseneck. DO NOT put all the shims on one side.
The quick attach should be centered in the
gooseneck.
2. Coat the quick attach pivot pin (Fig. 3-155, 4) with
an anti-seize compound. Insert the quick attach pivot
pin through the gooseneck, washers, shims and
quick attach. Use a tapered punch to line up the hole
in the pivot pin with the hole in the quick attach.
3. Insert the 5/8-11 x 5" capscrew (Fig. 3-155, 5),
saved, through the quick attach and pin. Secure the
capscrew in place with a new 5/8-11 elastic locknut (6).
Tighten securely.
Figure 3- 155 Quick Attach
4. Coat the rod end pivot pin (Fig. 3 -156, 1), saved,
with an anti-seize compound. Swing the rod end (2)
of the attachment tilt cylinder up and line up the rod
end with the mounting holes in the quick attach (3).
5. Insert the rod end pivot pin (Fig. 3 -156, 1) through
the lined-up holes. Use a tapered punch to line up
the capscrew hole in the pivot pin and the mounting
hole in the quick attach hub. Insert the 1/2-13 x 5"
capscrew (4), saved, through the quick attach hub
from the backside and secure in place with a new
1/2-13 elastic locknut (5). Tighten securely.
Figure 3-156 Rod End Pivot Pin
MH1720
2
3
4
6
5
1
2
3
MH0940
5
2 4
1
3
~