Fig. 3-63 – SkyTrak 6042 Service Manual User Manual
Page 73

3.27
Model 6042 Legacy
Origin 7/02
Boom
39. Place the lower clamp halves (Fig. 3-63, 5) on each
side of the auxiliary hydraulic (lower) tubes (6). 
Loosely secure the lower clamp halves to the 
stacking bolt with a clamp cover (7), saved, and a 
5/16-18 x 1-1/4" capscrew (8), saved. Verify that the 
tubes sit properly in all three tube clamp positions 
and the mounting plate. Tighten the capscrews 
securely to hold the lower tubes in place in all three 
positions. 
40. Fully tighten both auxiliary tube bulkhead
nuts (Fig. 3-62, 7 and 9).
Figure 3-63 Auxiliary Hydraulic and
Attachment Tilt Tube Clamps
41. Connect the attachment tilt extend hose
(Fig. 3 -64, 1), coming from the front tee on the 
bulkhead plate on the frame, to the attachment tilt 
cylinder extend tube assembly (2), on the mounting 
plate (3) on the rear left side of the boom. Remove 
all twists from the hose, and tighten the end securely 
to the end of the tube.
42. Connect the attachment tilt retract hose
(Fig. 3 -64, 4), coming from the rear tee on the 
bulkhead plate on the frame, to the attachment tilt 
cylinder retract tube assembly (5), on the mounting 
plate (3) on the rear left side of the boom. Remove 
all twists from the hose, and tighten the end securely 
to the end of the tube.
43. Connect the auxiliary hydraulic hose (Fig. 3-64, 6) for
the male nipple, coming from the front 45° fitting on 
the bulkhead plate on the frame, to the auxiliary tube 
assembly (7), on the mounting plate (3) on the rear 
left side of the boom. Remove all twists from the 
hose, and tighten the end securely to the end of the 
tube.
44. Connect the auxiliary hydraulic hose (Fig. 3-64, 8) for
the female nipple, coming from the rear 45° fitting on 
the bulkhead plate on the frame, to the auxiliary tube 
assembly (9), on the mounting plate (3) on the rear 
left side of the boom. Remove all twists from the 
hose, and tighten the end securely to the end of the 
tube.
Figure 3-64 Auxiliary Hydraulic and Attachment Tilt Hoses
MH1191
6
2
8
5
4
1
3
7
MA9790
8
9
6
3
4
3
2
2
5
7
9
1
1
5
4
7
8
6
