West Control Solutions KS98-1 - Manual (Page 80)

After Start-up, we see the adjacent controller page.
Now the setpoint is altered (See: page): Insert a setpoint and
confirm it. The controller will adapt the process value (simulated
by KS98-1 with its correcting variable reaction.
As a matter of fact, every controller must be matched to the pro-
cess characteristics. This refers mainly to control parameters
Xp1, Tn and Tv.
For detailed information including the self-tuning function, plea-
se, see section Controller CONTR, CONTR+ and PIDMA page: 223) in this manual.
Detailed information on this subject and on the self-tuning possibility is given in this manual and in section Controller
(CONTR, CONTR+ and PIDMA) of the operating instructions. The different KS 98-1 operating pages and the operating
principle of these pages are described in a separate document (operating manual) apart from the function-related ex -
planations of this manual.
The actual internal values of the instrument/simulator can be observed in the engineering tool.
+ This is helpful mainly when locating engineering errors.
On menu item:
Fixed functions – ET Functions – X-Disp : Display of analog
value for debug mode , internal ET display items (analog/di-
gital) can be selected.
For these items, positioning and soft-wiring are done as for
function blocks.
F4 ( Options – Debug ) can be used to activate the value
display (see Fig.: Debug information).
.
Building an engineering 9499-040-82711
II-80
Fig. 105
Fig. 106
Fig. 107: Debug Informationen