beautypg.com

Recipe 1 recipe 2 recipe 3, Start – West Control Solutions KS98-1 User Manual

Page 207

background image

w

2 = reset + stop: Programmer goes to rest condition

Wp0

At program end, the number of the last segment increased by 1 is output as active segment number (

SegNo output

of operating page and interface). This is required to bring the slave block to the end status safely with a segment pre -
set.

Start

The programmer uses a common start Wp0 for all programs. However, using an individual start for a recipe is possi -
ble as follows:

Use the of the 1st segment of each program as start value.

Set the relevant segment time (Tp1) to 0.

Set the search run parameter Smode to ’Search run in program sections‘. Now, the search run is not limited to the 1st
segment and program start at the process value in the 2nd segment is possible (see search run, page -> marking(SS)).

If each recipe shall have a separate reset (Wp0), function blocks REZEPT and VPARA can be used as shown up 40.
Note the calculation order (APROG r REZEPT r VPARA).

9499-040-82711

Programmer

APROG ( analog programmer (No. 24)) / APROGD ( APROG data (No. 25))

III-207

recipe 1

recipe 2

recipe 3

pshow

Fig. 40 Recipees with separate starting setpionts

Preparation

for

operation

operation

expired

program time

program

START

program

START

program

ENDE = RESET

operation

RESET

time

RESET

PRESET

PRESET

Process
value x

Wp0

Process
value x

Preparation

for

operation

Fig. 41 Profile with automatic reset at program end