West Control Solutions KS98-1 - Manual (Page 213)

Run, reset, preset and search are concerned, see following table:
Input field Operation Display FB input
Header Selection of slave block Display of slave data - : -
auto/manual Operating mode selection auto or manual - : -
setpoint
Automatic: programmer ,
Manual mode: operator setting in input field Active
- : -
Rec
If input ProgNo is wired, entering of the de-
sired recipe number is not possible over the
frontside!
indicates the actual recipe number.
ProgNo
Seg
If control input preset is wired, entering the de-
sired segmentnumber is not possible over the
frontside!
indicates the actual segment number
preset
tNetto
Entry of required programmer time (preset to time) indicates the run time total (with-
out pause)
preset
tRest No operation possible indicates the time until program end
Status
stop Stop the programmer programmer stopped
run
run Start the programmer the programmer was started
reset
The programmer is switched to segment 0
and’
stop‘
the programmer is switched to seg-
ment 0 and’
stop‘
reset
quit Leave the field without change
program direct adjustment of segment parameters segmentparameter
Notes related to the properties of the operating page
The display fields shown in bold and underlined letters on the picture above mark the elements which are switched
over when changing to a slave page (see sections Master/slave operation on page 215).
The remaining fields continue indicating statuses and values of the master page.
Recipe name:
Recipes can be selected in the reset status. Unless a user text (TEXT block at ProgNo input) is provided, ‘Rec n‘ is dis-
played (n stands for the current recipe number).
• The process value is visible only with the process value input connected.
• The segment number is adjustable only with preset to segment.
• The can be adjusted only during manual mode.
• Display of the remaining segment time is suppressed with preset to segment (e.g. with digital slave
programmers).
• The program net time is adjustable with preset to time.
• 3 statuses are displayed (partly adjustable, dependent on operating status):
– Status left: automatic / manual (adjustable)
– Status middle: halt / end (unless one of the two statuses is active, this display is omitted)
– Status right: stop / run / reset / search / program / quit / error
9499-040-82711 Programmer
APROG ( analog programmer (No. 24)) / APROGD ( APROG data (No. 25))
III-213