West Control Solutions KS98-1 - Manual (Page 239)

Configuration Effective controller parameters of a continuous controller
CFunc =
continuous
SplitRange
Popt Parameter set for self-tuning (only with CONTR+) 1...6
W0 1) Lower limit for Weff -29 999 ...999 999
W100 1) Upper limit for Weff -29 999 ...999 999
W2 1) Additional -29 999 ...999 999
Grw+ 2) gradient plus off / 0,001 ... 999 999
Grw- 2) gradient minus off / 0,001 ... 999 999
Grw2 2) gradient for W2 off / 0,001 ... 999 999
N0 Zero offset (effective only with CType=ratio controller) -29 999 ...999 999
a Factor a (effective only with CType=3-element control) -9,99 ... 99,99
Xsh1 3) Neutral zone (Xw > 0) 0,0 … 1000 [%]
Xsh2 3) Neutral zone (Xw < 0) 0,0 … 1000 [%]
Y2 Additional positioning value 0 … 100 [%]
Ymin Min. output limiting (-100) 0 … 100 [%]
Ymax Max. output limiting (-100) 0 … 100 [%]
Y0 Correcting variable working point (start-up correcting variable) -100...100 [%]
YOptm Positioning value during process at rest (not with PIDMA) 0...100 [%]
dYopt Self-tuning step height 5...100 [%]
Xp1(1...6) 3) 4) Proportional band 1 0,1 … 999,9 [%]
Xp2(1...6) 3) 4) Proportional band 2 (only with continuous controller split range) 0,1 … 999,9 [%]
Tn1(1...6) 4) Integral action time 0 … 999 999 [s]
Tv1(1...6) 4) Derivative action time 0 … 999 999 [s]
Titel Title of controller page (only display) 16 characters
Einh.X Process value unit (only display) 6 characters
W int 1) Internal after transmission of the engineering to KS 98-1 -29 999 ...999 999
A/H Controller status after transmission of the engineering to KS 98-1 0 or 1
1) The values must be specified in the process value unit, e.g. [°C, °F, bar, %, etc.]
2) The rate of change must be specified in units/minute e.g. °C/min). r see gradient control page 261.
3) % specifications are related to measuring range
Xn100 - Xn0 . There is no relationship to values W0 and W100.
4) ( 1...6) refers to the six parameter sets of CONTR+ (e.g. Xp1, Xp2, Xp3...Xp6).
9499-040-82711 Controller
Control behaviour III-239