West Control Solutions KS98-1 - Manual (Page 220)

Inputs/outputs
Digital inputs (DPROG):
hide
Display suppression (with hide = 1 the page is not displayed in the operation).
lock Adjustment blocking (with lock = 1 the values are not adjustable by means of keys ID).
run Program stop/run ( 0 = stop, 1 = run ) reset has highest priority
reset Program continue/reset (0 = continue, 1 = reset )
preset Program preset ( 1 = preset )
search Start programm search run (1 = search )
p-show Program editing enabled
halt
Program interruption (e.g. due to an exceeded bandwidth detected outside the programmer).
0 = program not halted
1 = program halted
manfree
Manual mode disabled 0 = switchover to manual mode not permitted
1 = switchover to manual mode is permitted
Digital outputs (DPROG):
run
Status program stop/run (0 = program stop ; 1 = program run)
reset Status program reset (1 = program reset)
end Status program end (1 = program end reached)
fkey Status H key / interface function `fkey’ (:pressing key H causes switch-over (0 or 1))
do1... do6 status of control outputs in the actual segment
preset
This output indicates a programmer preset operation. With a single preset command, a pulse is output for
the duration of one cycle (dependent on the time slot in which the programmer is classified). If the program-
mer is held in preset continuously, this output is always active.
0 = no preset status
1 = APROG stands in preset status
manual
This output indicates the progrmmer manual mode.
0 = APROG works in automatic mode
1 = APROG works in manual mode
Analog inputs (DPROG):
PSet
Preset value for program
DBlock Block number of 1st data function `APROGD’
ProgNo Required program number (recipe)
SlavNo SlavNo: Block number of a connected slave block (for coupling master and slave blocks (APROG or DPROG)
Analog inputs (DPROGD):
DBlock
Block number of cascadable data function `DPROGD’
Analog outputs (DPROG):
TNetto
Net program time ( ] Trun)
TBrutt Gross program time (] Trun + ] Tstop)
TRest Programmer rest time
SegNo Actual segment number
ProgNo Actual program number (recipe)
SegRest Remaining segment time
Bl-no Own block-number (e.g. for coupling master and slave blocks)
Analog outputs (DPROGD):
DBlock
Own block number
Parameter and configuration data
Parameter
DPROG Description Range Default
PMode Preset Mode:
Preset to segment Pres.time t
Preset to time Pres.seg.
RecMax Max.recipees 1..99 99
D0 Status of control outputs 6...1 with reset 0 / 1 per output 000000
Programmer 9499-040-82711
III-220 DPROG ( digital programmer (No. 27)) / DPROGD ( DPROG data(No. 28))