West Control Solutions KS98-1 - Manual (Page 281)

III-17.2 AINP3...AINP5 ( analog inputs 3...5 (No. 112...114) )
For standard signal connection
General
Functions ‘AINP3...AINP5’ are used for configuration and parameter setting of analog inputs INP3...INP5. They are
firmly allocated to block number 63...65 and are calculated in each time slot. The functions provide corrected measure -
ment values and measurement value statuses at their outputs.
For the general functions (scaling, error control, filter...) see AINP1 r Page 275
Inputs / outputs
Digital outputs:
fail Signals an input error (short-circuit, wrong polarity, ..)
Analog outputs:
Inp1 Signal input
Parameter and configuration data
Parameter Description Values Default
x1in Measured value correction P1, input -29999 ... 999 999 0
x1out Measured value correction P1, output -29999 ... 999 999 0
x2in Measured value correction P2, input -29999 ... 999 999 100
x2out Measured value correction P2, output -29999 ... 999 999 100
Configuration Description Values Default
Type
0...20 mA 0...20mA
t
4...20 mA 4...20mA
0...10 V 0...10V
2...10 V 2...10V
Fail
Fail function off disabled
t
Digital output fail = 1, y1 = x100 Upscale
Digital output fail = 1, y1 = x0 Downscale
Digital output fail = 1, y1 = XFail Subst.val.
Xkorr
Measured value correction off off
t
Measured value correction adjustable on
x0 Physical value at 0% effective only with standard signals
(0/4..20mA or 0/2..10V)
-29999 ... 999 999 0
x100 Physical value at 100% -29999 ... 999 999 100
Tfm Filter time constant [s] 0 ... 999 999 0,5
Inputs 9499-040-82711
III-281 AINP3...AINP5 ( analog inputs 3...5 (No. 112...114) )
Unit
Typ XFail
Fail
x0
x100
Tfm
x2out
Xkorr
x2in
x1out
x1in
fail
Inp6