West Control Solutions KS98-1 - Manual (Page 71)

II-4.5 Online operation
Display blocks (analog and digital)
In ‘Fixed functions‘ r ‘ET functions‘ (r Fig.: 91) display blocks (X-Disp and d-Disp) can be selected and inserted into
the engineering as special block (r Fig.: 92).
Like all other functions, these blocks can be given names in the parameter dialogue. Via ‘Options‘ r ‘Delete display
functions‘, all display blocks can be deleted simultaneously e.g. after finishing the engineering test.
Debug
The debug mode can be enabled/disabled either via the menu item “Options r Debug” or directly with F4. Operating
data are then exchanged cyclically (approx. 0,5s) with the KS 98-1 or SIM/KS 98-1. The generated display blocks will
show the relevant values. Too many display blocks will extend the cycle time.
Parameters can be changed online using the parameter dialog. After confirmation with “OK”, they are transmitted to
the KS 98-1. The results are displayed immediately.
Parameter changes via the KS 98-1 front panel are not transmitted to the PC during the debug mode.
9499-040-82711 Engineering tool operation
Online operation II-71
Fig.: 91
Fig.: 92