B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 41)

Airborne Enterprise CLI Reference Manual 41

A commit command must be used to save the SSH server credentials to the module,
this will make them persistent across restarts or power cycles.
If the credentials are not saved the module/server will need to be re-trusted the next
time the module restarts.
Use of SSH for pass data bridging is configured by setting wl-xmit-type ssh
(for the primary serial/UART interface) or wl-xmit-type-p2 ssh (for the
secondary serial/UART interface).
If the user is communicating with the module over a CLI Session on a serial
interface, when authenticating with the SSH server, the username and password
utilized by the modules SSH client is the same as that with which the user
entered when the auth command was issued at the start of the CLI Session. If
the module is automatically establishing the data bridge via serial-default
pass or serial-default-p2 pass, the username and password configured
through ssh-default-user and ssh-default-password are utilized.