B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 32)

32 Airborne Enterprise CLI Reference Manual
Command Description
wl-tcp-ip2-pX [IP Address]
The secondary target IP address of the TCP
server on the network to be used when the CLI
session on a serial port issues the PASS
command or if the serial-default setting is
PASS.
This command supports the serial port suffix,
by replacing the pX with p1 or p2 the
command parameter can be applied to a
specific serial port.
If the suffix is not included, the command
applies to the port the serial CLI session is
open on.
wl-tcp-port-pX [Port Number]
The port number used by the CLI server when
a serial interface initiates a TCP connection.
This value must match the port on which the
target TCP server is listening.
The port range is 0 – 65535 (default 2571).
This command supports the serial port suffix,
by replacing the pX with p1 or p2 the
command parameter can be applied to a
specific serial port.
If the suffix is not included, the command
applies to the port the serial CLI session is
open on.
Wl-tcp-timeout-pX [Time seconds]
Establishes the inactivity timeout for a TCP
connection initiated by the CLI session on a
serial interface using the pass or serial-
default pass
command.
A value of 0 disables the timeout.
This command supports the serial port suffix,
by replacing the pX with p1 or p2 the
command parameter can be applied to a
specific serial port.
If the suffix is not included, the command
applies to the port the serial CLI session is
open on.