B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 254)

254 Airborne Enterprise CLI Reference Manual
Wl-xmit-type / wl-xmit-type-p1
Command wl-xmit-type | wl-xmit-type-p1
Arguments tcp | udp | ssh | both
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default tcp
Description Configures the outbound traffic transmission protocol for the Serial 1 (UART1) interface when a data
tunnel has been established.
Tcp Only TCP/IP protocol is used for data transmission.
Udp Only UDP protocol is used for data transmission.
Ssh
Only TCP/IP protocol traffic, encrypted within a Secure Shell (SSH) is
allowed.
Both
Both TCP and UDP protocols are used for data transmission. Two packets
are sent
It is required that the data tunnel, TCP and UDP server configurations have been completed for any
given transmission protocol to be used.
A data tunnel must exist on the Serial 1 (UART1) interface for transmissions to occur.
Use of the –p1 suffix is optional.
Wl-xmit-type-p2
Command wl-xmit-type-p2
Arguments tcp | udp | ssh | both
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default tcp
Description Configures the outbound traffic transmission protocol for the Serial 2 (UART2) interface when a data
tunnel has been established.
Tcp Only TCP/IP protocol is used for data transmission.
Udp Only UDP protocol is used for data transmission.
Ssh
Only TCP/IP protocol traffic, encrypted within a Secure Shell (SSH) is
allowed.
Both
Both TCP and UDP protocols are used for data transmission. Two packets
are sent
It is required that the data tunnel, TCP and UDP server configurations have been completed for any
given transmission protocol to be used.
A data tunnel must exist on the Serial 2 (UART2) interface for transmissions to occur.