B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 128)

128 Airborne Enterprise CLI Reference Manual
escape
Command escape
Arguments [ASCII Hex]
Security
Level
Read: 2 (data)
Write: 3 (config)
Device Type All
Default 7E7E7E6473 (UART: equivalent to ~~~ds)
FF7E414244 (Serial: equivalent to ÿ~ABD)
Description Sets the escape string sequence. The sequence must be 5 ASCII characters long, equivalent to 10
ASCHEX digits.
These must be the last 5 bytes transferred (no CR, LF or any other trailing bytes can follow), or the
escape sequence will be ignored.
Can be set to a desired sequence or can be disabled with the off argument.

This command has been deprecated, it is recommended that the following commands
be used to set the escape string and enable or disable its use.
esc-str or esc-str-p1
esc-str-p2
esc-mode-serial
or esc-mode-serial-p1
esc-mode-serial-p2
esc-mode-lan
or esc-mode-lan-p1
esc-mode-lan-p2