Wl-udp-xmit / wl-udp-xmit-p1, Wl-udp-xmit-p2 – B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual User Manual

Page 251

Airborne Enterprise CLI Reference Manual

251

wl-udp-xmit / wl-udp-xmit-p1

Command

wl-udp-xmit | wl-udp-xmit-p1

Arguments

disable | ucast | bcast | both

Security

Level

3 (config)

Device Type Serial | UART | SPI

Default

disable

Description

Configures the outbound UDP retransmission mode for a TCP/IP data tunnel connected to Serial 1

(UART1) interface. When enabled the device server will retransmit the data payload of a TCP/IP packet
using a UDP packet, this parameter determines the UDP packet type to be retransmitted.

Disable

Disables outbound packet retransmission. No additional UDPO transmissions
are made.

Ucast

Enables UDP unicast retransmission. A UDP Unicast packet is sent using the

target address of the TCP/IP packet.

Bcast

Enables UDP broadcast retransmission. A UDP broadcast packet is sent

using the payload of the initial TCP/IP packet.

Both

Enables both Unicast and Broadcast UDP retransmission.

If wl-udp-xmit both is set, three packets will be sent TCP/IP, UDP Unicast and UDP Broadcast.

Use of the –p1 suffix is optional.

wl-udp-xmit-p2