B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 250)

250 Airborne Enterprise CLI Reference Manual
wl-udp-rxport / wl-udp-rxport-p1
Command wl-udp-rxport | wl-udp-rxport-p1
Arguments
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default 8023
Description Configures the UDP port number for the Serial 1 (UART1) tunnel will listen for UDP communications. The
port will accept both unicast and broadcast packets and transfer their data payloads to the Serial 1
(UART1) interface.
Data will only be transferred when a data tunnel has been established with Serial 1 (UART1) interface.
The pass or serial-default pass commands, issued from the Serial 1 (UART1) interface are used
to establish the data tunnel prior to receiving UDP transmissions.
The port number must match the port the network UDP server is transmitting packets to.
The port range is 0 – 65535.
Use of the –p1 suffix is optional.
wl-udp-rxport-p2
Command wl-udp-rxport-p2
Arguments
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default 8024
Description Configures the UDP port number for the Serial 2 (UART2) tunnel will listen for UDP communications. The
port will accept both unicast and broadcast packets and transfer their data payloads to the Serial 2
(UART2) interface.
Data will only be transferred when a data tunnel has been established with Serial 2 (UART2) interface.
The pass or serial-default-p2 pass commands, issued from the Serial 2 (UART2) interface are
used to establish the data tunnel prior to receiving UDP transmissions.
The port number must match the port the network UDP server is transmitting packets to.
The port range is 0 – 65535.