B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 197)

Airborne Enterprise CLI Reference Manual 197
serial-default-p2
Command serial-default-p2
Arguments cli | listen | pass
Security
Level
Read: 3 (config)
Write: 4 (OEM)
Device Type Serial, UART
Default cli
Description Configures the default mode for the Serial 2 (UART2) interface. The CLI server will use the defined mode
at start-up of the device server.
cli
The interface will start in CLI mode as defined in section 6.3.1.
In this mode the UART will accept and process CLI commands. Authentication is required
for access to the CLI server.
listen
The interface will start in listen mode as defined in section 6.3.5.
In this mode the Serial 2 (UART2) interface will accept requests to establish a data
tunnel.
pass
The interface will start in pass mode as defined in sections 6.3.2 and 6.3.3.
In this mode the device server will attempt to make a connection with the defined
network server. It is necessary that a wireless or Ethernet connection be established for
this setting to be successful.
If the network server is not available the device server will continue to attempt to
connect until the server becomes available or the Serial 2 (UART2) interface is
interrupted by sending the escape sequence to the interface.