B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 244)

244 Airborne Enterprise CLI Reference Manual
wl-tunnel-mode / wl-tunnel-mode-p1
Command wl-tunnel-mode | wl-tunnel-mode-p1
Arguments tcp | udp | sds
Security
Level
Read: 3 (config)
Write: 4 (OEM)
Device Type Serial | UART | SPI
Default tcp
Description Configures the communication protocol that will be used by the tunnel port (wl-tunnel-port)
assigned to the Serial 1 (UART1) interface, for incoming communications.
Tcp Sets TCP/IP as the protocol on the tunnel port.
Udp Sets UDP as the protocol on the tunnel port.
Sds Sets up SDS mode as the protocol for tunneling.
The data tunnel must be enabled (wl-tunnel 1) for communications to be successful.
Non-matching protocols attempting to connect to the tunnel port will be ignored.
The use of the –p1 suffix is optional.
wl-tunnel-mode-p2
Command wl-tunnel-mode-p2
Arguments tcp | udp | sds
Security
Level Read: 3 (config)
Write: 4 (OEM)
Device Type Serial | UART | SPI
Default tcp
Description Configures the communication protocol that will be used by the tunnel port (wl-tunnel-port-p2)
assigned to the Serial 2 (UART2) interface, for incoming communications.
Tcp Sets TCP/IP as the protocol on the tunnel port.
Udp Sets UDP as the protocol on the tunnel port.
Sds Sets up SDS mode as the protocol for tunneling.
The data tunnel must be enabled (wl-tunnel-p2 1) for communications to be successful.
Non-matching protocols attempting to connect to the tunnel port will be ignored.