B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 131)

Airborne Enterprise CLI Reference Manual 131
esc-str / esc-str-p1
Command esc-str | esc-str-p1
Arguments [ASCII Hex]
Security
Level
Read: 2 (data)
Write: 3 (config)
Device Type All
Default 7E7E7E6473 (UART) | FF7E414244 (Serial)
Description Sets the escape string sequence for data tunnels using the Serial 1 (UART1) port, this string will apply to
both the serial and wireless interfaces. The sequence must be 5 ASCII characters long, equivalent to 10
ASCHEX digits.
These must be the last 5 bytes transferred (no CR, LF or any other trailing bytes can follow), or the
escape sequence will be ignored.
7E7E7E6473 ~~~ds
FF7E414244 ~ABD.
Use of the –p1 suffix on the command is optional.
esc-str-p2
Command esc-str-p2
Arguments [ASCII Hex]
Security
Level
Read: 2 (data)
Write: 3 (config)
Device Type All
Default 7E7E7E6473 (UART) | FF7E414244 (Serial)
Description Sets the escape string sequence for data tunnels using the Serial 2 (UART2) port, this string will apply to
both the serial and wireless interfaces. The sequence must be 5 ASCII characters long, equivalent to 10
ASCHEX digits.
These must be the last 5 bytes transferred (no CR, LF or any other trailing bytes can follow), or the
escape sequence will be ignored.
7E7E7E6473 ~~~ds
FF7E414244 ~ABD.