B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 247)

Airborne Enterprise CLI Reference Manual 247
wl-udp-ip / wl-udp-ip-p1
Command wl-udp-ip | wl-udp-ip-p1
Arguments
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default 0.0.0.0
Description Configures the network server IP address for the Serial 1 (UART1) interface to use when the CLI session
on the Serial 1 (UART1) interface initiates UDP communications. The address is applied when the pass
or serial-default pass commands are used.
This address will be used when wl-xmit-type udp has been configured.
This parameter does not require a commit and restart; it will be applied the next time pass is issued,
after the address has been changed.
Use of the –p1 suffix is optional.
wl-udp-ip-p2
Command wl-udp-ip-p2
Arguments
Security
Level 3 (config)
Device Type Serial | UART | SPI
Default 0.0.0.0
Description Configures the network server IP address for the Serial 2 (UART2) interface to use when the CLI session
on the Serial 2 (UART2) interface initiates UDP communications. The address is applied when the pass
or serial-default-p2 pass commands are used.
This address will be used when wl-xmit-type-p2 udp has been configured.
This parameter does not require a commit and restart; it will be applied the next time pass is issued,
after the address has been changed.