B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 111)

Airborne Enterprise CLI Reference Manual 111
conn-led
Command conn-led
Arguments enable | disable
Security
Level
3 (config)
Device Type All
Default enable
Description Controls the function of the GPIO pin (F6) used for the LED_CON, pin 23.
The CONN LED indicates if a TCP connection or a data tunnel has been established. The specific
functionality is described by the wl-con-led command.
enable Defines the output of GPIO pin F6 as the CONN.
disable Defines the GPIO pin F6 for use as a general purpose digital I/O pin.
The LED_CON must be disabled for io-dir-f, io-pullup-f and io-write to affect GPIO F6.
data-bits / data-bits-p1
Command data-bits | data-bits-p1
Arguments 7 | 8
Security
Level 3 (config)
Device Type UART | Serial | Ethernet
Default 8
Description Sets the data bit length for serial port 1 (UART1) in bits.
Use of the –p1 suffix is optional.
data-bits-p2
Command data-bits-p2
Arguments 7 | 8
Security
Level
3 (config)
Device Type UART | Serial | Ethernet
Default 8
Description Sets the data bit length for serial port 2 (UART2) in bits.