B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 245)

Airborne Enterprise CLI Reference Manual 245
wl-tunnel-port / wl-tunnel-port-p1
Command wl-tunnel-port | wl-tunnel-port-p1
Arguments
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default 8023
Description Configures the tunnel port number for the Serial 1 (UART1) interface. The CLI server will process TCP/IP
connection requests on this port as a request to open a CLI session in pass mode.
The tunnel port does not require authentication using the CLI command (auth
) and will automatically establish a data tunnel with the Serial 1 (UART1) interface only if it
is in listen mode.
The port range is 0 – 65535.
The use of the –p1 suffix is optional.
wl-tunnel-port-p2
Command wl-tunnel-port-p2
Arguments
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default 8024
Description Configures the tunnel port number for the Serial 2 (UART2) interface. The CLI server will process TCP/IP
connection requests on this port as a request to open a CLI session in pass mode.
The tunnel port does not require authentication using the CLI command (auth
) and will automatically establish a data tunnel with the Serial 2 (UART2) interface only if it
is in listen mode.
The port range is 0 – 65535.