B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 126)

126 Airborne Enterprise CLI Reference Manual
eap-phase1
Command eap-phase1
Arguments peaplabel=0 | peaplabel=1| peapver=0 | peapver=1 | peap_outer_success=0 | include_tls_length=1|
result_ind=1 | crypto_binding=0 | crypto_binding=1 | crypto_binding=2 |
Security
Level 3 (config)
Device Type All
Default [blank]
Description Phase1 (outer authentication, i.e., TLS tunnel) parameters.
peaplable=0
Forces a new label to be used during key derivation when PEAPv1 or newer is
being utilized. Most server PEAPv1 implementations use this value.
peaplabel=1
Forces a new label to be used during key derivation when PEAPv1 or newer is
being utilized. Some servers may require this setting for use with PEAPv1.
peapver=0 Forces use of PEAPv0.
peapver=1 Forces use of PEAPv1.
peap_outer_succes
s=0
Terminates PEAP authentication on tunneled EAP-Success.
This is required with some RADIUS servers that implement draft-josefsson-
pppext-eap-tls-eap-05.txt (e.g., Lucent NavisRadius v4.4.0 with PEAP in
"IETF Draft 5" mode)
include_tls_lengt
h=1 Used to force supplicant to include TLS message length field in all TLS
messages even if they are not fragmented,
result_ind=1 Used to enable EAP-SIM and EAP-AKA to use protected result indication.
crypto_binding=0 Do not use Crypto Binding for PEAPv0.
crypto_binding=1 Use Crypto Binding for PEAPv0, if the server supports it (default).
crypto_binding=2 Require Crypto Binding for PEAPv0.