B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 160)

160 Airborne Enterprise CLI Reference Manual
io-dir-g
Command io-dir-g
Arguments 0 | 1
Security
Level
Read: 2 (data)
Write: 3 (config)
Device Type All
Default 0
Description Sets the direction of the g GPIO port to input or output.
The command requires a single integer value that represents the state to be configured.
0 Bit is set as an output
1 Bit is set as an input
Any attempt to set an unavailable port or configure a port to an illegal state will be ignored.
This command requires a commit command to be made persistent.
Requires a restart to take effect.
The following exceptions apply:
g0 Read or Write
g1 Read or Write
g2 Read or Write
g3 N/A
g4 N/A
g5 N/A
g6 Read or Write
g7 Read or Write