B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 195)

Airborne Enterprise CLI Reference Manual 195
serial-assert / serial-assert-p1
Command serial-assert | serial-assert-p1
Arguments xon | xoff
Security
Level
3 (config)
Device Type All
Default xon
Description Allows the serial port 1 (UART1) software flow control to be asserted or not.
This command can be issued to a TCP based CLI session and cause the flow control to be applied
immediately on serial port 1 (UART1).
This commands argument can be made persistent across restarts or power cycles through issuing a
commit after applying the command. The saved value will be applied at start-up.
This command requires software flow control to be enabled, see flow for more details.
Use of the –p1 suffix is optional.
serial-assert-p2
Command serial-assert-p2
Arguments xon | xoff
Security
Level 3 (config)
Device Type All
Default xon
Description Allows the serial port 2 (UART2) software flow control to be asserted or not.
This command can be issued to a TCP based CLI session and cause the flow control to be applied
immediately on serial port 2 (UART2).
This commands argument can be made persistent across restarts or power cycles through issuing a
commit after applying the command. The saved value will be applied at start-up.
This command requires software flow control to be enabled, see flow-p2 for more details.