B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 162)

162 Airborne Enterprise CLI Reference Manual
io-pullup-f
Command io-pullup-f
Arguments 1 | 0
Security
Level
Read: 2 (data)
Write: 3 (config)
Device Type All
Default 1
Description Enables or disables the internal pull-up resistor for the f GPIO port.
The command requires a single parameter that represents the state to be configured.
1 Enables the internal pull-up resistor
0 Disables the internal pull-up resistor
Any attempt to set a read only port will be ignored.
This command requires a commit command to be made persistent.
Requires a restart to take effect.
The following exceptions apply:
f0 Read (POST output)
f1 Read or Write
f2 Read (RF_LINK output)
f3 Read (WLN_CFG output)
f4 Read or Write
f5 Read or Write
f6 Read (LED_CON output)
f7 Read or Write
When the LED signal has not been disabled those bits indicated as LED Outputs can only be read in
order to determine the state of the LED output (See WLNN DP500 Family Databook for details). To
disable the LED‟s use one of the following commands post-led, rf-link-led, wln-cfg-led and
conn-led
.
Any attempt to set an unavailable port or configure a port to an illegal state will be ignored.