B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 223)

Airborne Enterprise CLI Reference Manual 223
wl-dhcp-server
Command wl-dhcp-server
Arguments disable | enable
Security
Level
3 (config)
Device Type All
Default disable
Description Enables or Disables the DHCP server for wireless clients. With the DHCP server enabled the wireless
interface will provide IP configurations for any DHCP requests from clients on the wireless interface.
Only available in Access Point mode (wl-type m).
The issued DHCP configurations are determined as follows:
disable Disables DHCP server on wireless interface.
enable Enables DHCP server on wireless interface.
wl-dhcp-vendorid
Command wl-dhcp-vendorid
Arguments [ASCII Text]
Security
Level 3 (config)
Device Type All
Default Empty String
Description Configures the DHCP Vendor Class ID String to use in the DHCP requests.
Parameter can by up to 31 ASCII characters long.
wl-dtim-int
Command wl-dtim-int
Arguments [Integer]
Security
Level
3 (config)
Device Type All
Default 2
Description Configures the wireless interface DTIM interval in terms of Beacon counts.
A value of 2 means every other beacon. This value is only applicable in Access Point mode.
Range is 1 - 10 beacons.