beautypg.com

Figure 2, Command – B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual User Manual

Page 34

background image

34

Airborne Enterprise CLI Reference Manual

Figure 2 - Bridging from a serial Interface Automatically at Startup Using the Serial-Default

Command

8.1.2 Bridging from a TCP connection on the wl-telnet-port

A user or OEM application connected over TCP to the wl-telnet-port of the
module may create a data bridge to a serial interface by issuing the pass
command. The pass command will succeed if there is no other data bridge
active and the CLI Session on a serial interface is in LISTEN Mode. The following
figure illustrates a sequence of commands that create a data bridge from the
TCP connection:

See also other documents in the category B&B Electronics Accessories communication: