B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 238)

238 Airborne Enterprise CLI Reference Manual
wl-tcp-ip-p2
Command wl-tcp-ip-p2
Arguments
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default 0.0.0.0
Description Configures the primary network servers IP address for the Serial 2 (UART2) interface to use when the
CLI session on the Serial 1 (UART1) interface initiates a TCP connection. The address is used when the
pass
or serial-default-p2 pass commands are used.
If the IP address is empty or the connection is unsuccessful the CLI server will attempt a connection to
the server IP address defined by wl-tcp-ip2-p2.
wl-tcp-ip2-p2
Command wl-tcp-ip2-p2
Arguments
Security
Level
3 (config)
Device Type Serial | UART | SPI
Default 0.0.0.0
Description Configures the secondary network servers IP address for the Serial 2 (UART2) interface to use when the
CLI session on the Serial 2 (UART2) interface initiates a TCP connection.
This address is used when the pass or serial-default-p2 pass commands are used and either
the primary IP address (wl-tcp-ip-p2) is empty or the connection attempt to the primary IP address
failed.