B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 235)

Airborne Enterprise CLI Reference Manual 235
wl-sleep-status
Command wl-sleep-status
Arguments none
Security
Level
2 (data)
Device Type All
Default
Description If the radio is currently asleep, displays 'sleep'. Otherwise, displays the current 'pm-mode', either
'active' or 'doze'.
If the module has two serial ports, then both ports need to agree on the sleep state. For example, if
SP1 is in “pm-mode sleep”, but SP2 is “pm-mode active”, the module is prevented from going to sleep
until both ports are in “pm-mode sleep”, either programmatically via the CLI command, or from the wl-
sleep-timer expiration.
wl-sleep-timer / wl-sleep-timer-p1
Command wl-sleep-timer | wl-sleep-timer-p1
Arguments [integer]
Security
Level 3 (config)
Device Type UART | Serial | SPI
Default 0
Description Configures he inactivity time (in seconds) on Serial 1 (UART1) interface before the radio will transition
to sleep mode. Data transfer to and from the UART will reset the timer.
The timer has a range of 0 – 300 seconds.
A value of zero (0) disables the wl-sleep-timer.
Use of the –p1 suffix is optional.