B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 134)

134 Airborne Enterprise CLI Reference Manual
eth-dhcp-fb
Command eth-dhcp-fb
Arguments enable | disable
Security
Level
3 (config)
Device Type Ethernet
Default Disable (UART and Serial), Enable (SPI and Ethernet)
Description Configures DHCP client fallback on the Ethernet interface. If the DHCP client fails to successfully complete
DHCP before the eth-dhcp-acqlimit time is exceeded, the Ethernet interface will use the fallback
settings for the modules IP configuration.
enable
Enables DHCP (Client) fallback on the Ethernet interface.
Will use the settings from eth-dhcp-fbip, eth-dhcp-fbgateway and
eth-dhcp-subnet
for the Ethernet IP configuration.
disable Disables DHCP (Client) fallback on the Ethernet interface.

If eth-dhcp-fb is disabled and DHCP fails, the Ethernet interface configuration will use
0.0.0.0
for the eth-ip and eth-subnet values. The eth-gateway will use the
wl-gateway setting.
The default setting is disable for the UART and Serial devices and enable for the SPI and Ethernet
devices.