B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 140)

140 Airborne Enterprise CLI Reference Manual
eth-gateway
Command eth-gateway
Arguments [ASCII Text: Valid IP address]
Security
Level
3 (config)
Device Type Ethernet
Default 192.168.2.1
Description Configures the IP address of the Ethernet gateway.
This is the IP address used by the client to communicate with the gateway (module).
The IP address of the client and the Ethernet gateway must be in the same subnet for IP routing to work
correctly.
Must be ASCII text string with XXX.XXX.XXX.XXX format, where XXX can be 0-255. The resultant IP
address must not be 0.0.0.0.

The subnet for the wired IP and gateway IP addresses (Ethernet) and public IP address
(802.11), obtained by the module via the wireless interface, and must not be the same.
eth-info
Command eth-info
Arguments [none]
Security
Level
2 (data)
Device Type Ethernet
Default [blank]
Description This command provides comprehensive status information on the Ethernet interface of the Airborne
Device Server.
Example:
Module Firmware Version: 1.10
Link Status: Connected
Ethernet MAC Address: 000B280040D2
Link Speed: 10Mb/s
Duplex: Full
IP Address: 192.168.2.1
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.1.3
Primary DNS: 192.168.1.3
Secondary DNS: 192.168.1.4
Up Time (Sec): 21854