B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 163)

Airborne Enterprise CLI Reference Manual 163
io-pullup-g
Command io-pullup-g
Arguments 1 | 0
Security
Level
Read: 2 (data)
Write: 3 (config)
Device Type All
Default 1
Description Enables or disables the internal pull-up resistor for the g GPIO port.
The command requires a single parameter that represents the state to be configured.
1 Enables the internal pull-up resistor
0 Disables the internal pull-up resistor
Any attempt to set a read only port will be ignored.
This command requires a commit command to be made persistent.
Requires a restart to take effect.
The following exceptions apply:
g0 Read or Write
g1 Read or Write
g2 Read or Write
g3 N/A
g4 N/A
g5 N/A
g6 Read or Write
g7 Read or Write