B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 129)

Airborne Enterprise CLI Reference Manual 129
esc-mode-lan / esc-mode-lan-p1
Command esc-mode-lan | esc-mode-lan-p1
Arguments off | on
Security
Level
Read: 2 (data)
Write: 3 (config)
Device Type UART, Serial
Default on
Description Configures the escape processing mode for the wireless interface when a tunnel has been established
with Serial 1 (UART1) port.
on Enables escape sequence checking on the wireless interface.
off Disables escape sequence checking on the wireless interface.
If escape sequence checking is disabled it will not be possible to break from a data tunnel using the
wireless interface connection.
Use of the –p1 suffix on the command is optional.
esc-mode-lan-p2
Command esc-mode-lan-p2
Arguments off | on
Security
Level Read: 2 (data)
Write: 3 (config)
Device Type UART, Serial
Default on
Description Configures the escape processing mode for the wireless interface when a tunnel has been established
with Serial 2 (UART2) port.
on Enables escape sequence checking on the wireless interface.
off Disables escape sequence checking on the wireless interface.
If escape sequence checking is disabled it will not be possible to break from a data tunnel using the
wireless interface connection.