B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 191)

Airborne Enterprise CLI Reference Manual 191
radio-startup
Command radio-startup
Arguments on | off | sleep
Security
Level
3 (config)
Device Type All
Default on
Description This command defines the start-up state of the radio after a power cycle or restart. The command is
persistent across power cycles and has significant impact on the operation of the device once the boot
cycle has completed.
The options for this command are:
on
In this mode the radio is placed in the predefined pm-mode (active or doze) and
will immediately attempt to associate with its configured SSID. This constitutes the
normal operation of the device server and is the default value.
off
This mode is intended for those environments which prohibit radio transmission
except under tightly controlled conditions. It is analogous to the airplane mode
supported by mobile phones.
In this mode, the radio driver is loads but the radio is immediately put into a deep
sleep. The radio can only be awoken via the radio-on or apply-cfg radio
commands.
sleep
In this mode the radio driver loads but the radio is immediately put into a deep
sleep. The radio can be awoken by either a single character transmitted on the
UART/serial interface or by the pm-mode wakeup command.
This mode is intended for those applications with low frequency data
transmissions.