B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 139)

Airborne Enterprise CLI Reference Manual 139
eth-dhcp-server
Command eth-dhcp-server
Arguments disable | enable
Security
Level
3 (config)
Device Type Ethernet
Default disable – UART, Serial, SPI; enable - Ethernet
Description Enables or Disables the DHCP server when the Ethernet interface mode is configures as a router. With the
DHCP server enabled the Ethernet interface to provide IP configurations for any DHCP requests from
clients on the Ethernet interface.
The issued DHCP configurations are determined as follows:
disable Disables DHCP server on Ethernet interface.
enable Enables DHCP server on Ethernet interface.
This command requires that eth-role router be configured.
The default setting is 0.
eth-dhcp-vendorid
Command eth-dhcp-vendorid
Arguments [ASCII Text: Vendor ID]
Security
Level
3 (config)
Device Type Ethernet
Default [None]
Description Configures the DHCP Vendor Class ID String to use in the DHCP requests for the Ethernet interface.
Up to 31 characters.
Default is an empty string.