B&B Electronics WLNN-AN(ER,SE,SP.EK)-DP551 - Manual - Manual (Page 152)

152 Airborne Enterprise CLI Reference Manual
get-cfg
Command get-cfg
Arguments [ASCII Text – filename]
Security
Level
3 (config)
Device Type All
Default [blank]
Description Will cause the device server to retrieve a configuration file from the FTP server identified in the parameters
defined by the following commands:
ftp-server-path
ftp-server-address
ftp-user
ftp-password
Once the download is complete it is necessary for the save command to be issued, this will cause the
configuration file to be stored to the device server.
There are two valid configuration files that may be down loaded:
user_config.txt
User configuration file. This file contains the user configuration
parameter names and values.
oem_config.txt
OEM default configuration file. This contains the OEM default settings for
the device server. These settings are installed upon the issuing of a
factory reset command or hardware factory reset input.
user_enc_config.uue
Encrypted user configuration file. This file contains sensitive user
configuration parameter names and values. See cfg-encrypt for
details.
For the Serial/UART/SPI device servers it is required that the device is associated and authenticated with a
network and has a valid IP address before issuing this command.
The Ethernet Bridge server supports the use of this command over the wired interface.